How To Fix Water Damaged Wood Trim

How to Repair Rotted Wood Trim

Wood, especially exterior wood trim molding, can get saturated with water and rot in isolated spots making it necessary to replace the whole thing to restore the trim. In many cases, to save the toll and work of replacement, this damage can be repaired with an epoxy wood filler.

Several manufacturers make a kit for repairing rotted wood like this that includes a stabilizer to harden the surrounding wood and a two-part putty which when mixed, volition set to a rock-hard patch that can be sanded and painted simply like real woods. It can also be drilled, cut, and shaped with the same tools used to work forest.

Remove the Rotted Wood

Before you lot start, make sure the expanse is completely dry and then dig all the soft, loose, and rotted wood away. Coat the sound wood that remains with a liquid stabilizer, this will harden the forest and form a solid foundation for the repair putty. A hardener like this is usually included in a repair kit or you can buy one like Bondo® —Rotted Wood Stabilizer— separately.

Reinforce Deep Damage

If the damage is very deep, drive nails into the sound forest, every few inches or so to reinforce the patching putty. Use nails with a broad caput similar sinkers and bulldoze them so the heads are a bit below the finish surface of the wood profile.

Build a Grade

If the impairment is very deep, build a form around the area to hold the epoxy shape until it sets. Employ small pieces of thin plywood or a similar light, rigid fabric and tack them along the face of the wood profile on all exposed sides to form a bandage.

Mix the Filler

Follow the directions on the container to mix plenty epoxy to fill the damaged area. Use a small plastic tube similar tupperware and a putty knife to mix the epoxy and apply information technology correct away. If the patch is very deep information technology may have two or more applications to fill it out completely, let each application harden before applying the next.

Apply the Filler

Once the putty is mixed, piece of work quickly to fill the patch before it can set, usually 5 to 10 minutes. If you have small crevices that are incommunicable to attain with a putty knife, clasp the epoxy into them using a plastic pocketbook with a small pigsty cut in one corner as a funnel.

For deeper damage, cascade the epoxy into the cast while using a putty knife to button it into all the sides. On vertical surfaces the filler will run off and must be held in place with a slice of plywood or other rigid, flat cloth until it sets.

Fill the Course

Fill the grade to overflowing with epoxy to allow for sanding and shaping it to course the new wood surface. In order to restore the surface, the filler must protrude above the original level of the surrounding trim.

Shape the Filler

As soon as the epoxy has set yous tin can begin honing information technology to the shape y'all demand. Remove the plywood form and use a paint scraper to shave the excess downwardly to a rough surface that's level with the surrounding wood. Work earlier the putty tin can harden completely, normally nearly 20 or xxx minutes.

After scraping off the excess filler, mix a pocket-size amount of epoxy and apply a thin coat over the whole repair to fill up in whatsoever pits or scratches in the surface.

Sand to Finish

Permit the filler gear up and sand the surface smooth using 80 and then 120 dust sandpaper. Use a sanding cake to make removing the hard fabric easier and to help keep the surface level and square.

When the patch has set up completely and is no longer warm, prime with an oil-based primer and and so paint information technology with the rest of the wood.

How To Fix Water Damaged Wood Trim,

Source: https://www.do-it-yourself-help.com/repair-rotted-wood-trim.html

Posted by: marchfaryinly.blogspot.com

Share this post